Shaved ice machine program operation
Qingdao cold machine wholesale Small make up to tell you Shaved ice machine program operation
1, ice crusher should be installed in the work in the enough supporting force, and a proper distance with the ground.
2, before plug-in power, first check the power supply voltage used, consistent with the machine voltage is used, the socket is in line with the safety standards, and has installed leakage protection switch and good earthed. Confirm all accord with the requirement of electricity.
3, before starting, put ice breaking from around 20 mm in diameter, can be put into the cylinder, top with convex had expected TongKou advisable. Note to open the power switch, after waiting for motor driving force plate rotating plate pressure is expected to cover the handle to allow down, then through fastening chop rotating blade of the knife dish on the ice. But when operating pressure is expected to cover the handle down may not be too hard and to avoid motor block to damage the motor. And should pay attention to allowance after the ice is expected to reduce, added new ice block material in a timely manner.
Grains of ice after 4, chopped, flow through the discharge port is served. To pay more attention to discharging mouth discharge smoothly, cannot be blocked, otherwise it will cause stuck the knife dish, motor burn out. If discover the knife dish is stuck, should immediately lift pressure is expected to cover handle, close the switch, remove the plug, timely troubleshooting.
5, ice thickness can be by adjusting the blade mouth bulging disc height, adjusted to remove the protection switch device of plastic tray, loosen screw fixed bend, cylinder is extracted and then loose fastening screw plate operation, remove the knife dish, then loosen the screw blade pressure, according to your request, installed, and then press the order and put the knife dish and put back in place.
